Maintenance of electric forklift battery

Maintenance of the mouth battery:

One, the place to pay attention

1. Liquid level

Lower than the rated liquid level will shorten the service life of the battery, and too little electrolyte will cause the battery to heat and damage. Therefore, it must be frequently injected

Whether the electrolyte is sufficient.

2. Terminal, wire, cover

The joints of the battery terminals and the connections with the wires must be checked frequently for corrosion caused by oxidation. At the same time, check whether the cover is deformed or not.

Whether there is fever.

3. Appearance

Dirty surface of the battery will cause leakage. Keep the surface of the battery clean and dry at all times.

2. Maintenance

1. Add water

Add distilled water according to the specified liquid level. Do not add too much distilled water in order to extend the time between adding water. Adding too much water will cause the electrolyte to overflow.

Cause leakage.

2. Maintenance of terminal, wire and cover

It must be prevented by professional and technical personnel designated by the manufacturer.

3. Clean

If it is not too dirty, you can wipe it with a damp cloth. If it is very dirty, remove the battery from the car, rinse it with water and let it dry naturally.

Maintenance of forklift battery:

1. Before cutting off the connection between the battery and the charger, first check the display of the charger and the record of the charger.

An error message is displayed-the charging of the battery is generally not finished, and the charger has interrupted the charging process when a fault occurs. At this time, you need to contact the after-sales service personnel

contact. When checking to confirm that the charging condition is normal, record the charging time of the charger, and then turn off the output after the average voltage of the monomer at the end of the capacity absorption charge.

Open the battery and charger connection.

2. Clean the dust on the surface of the battery to avoid the formation of a discharge loop on the surface of the battery and shorten the discharge time of the battery. But please be careful not

To rinse with water, just wipe with a clean cloth.

3. Check the connection between the cells of the battery and the connection of the battery's power output line to ensure that the battery is well connected to ensure electricity

The flow output is unblocked.

4. Before connecting the plug of the battery to the power socket of the electrical appliances of the sensitive car, first check whether the electrolyte level of each monomer of the battery is in the

Within the standard range, if the electrolyte level is low, it is necessary to add distilled water to the standard range (-generally require the electrolyte level to cover the electrode plate 10-

15mm. If possible, you can use the automatic water filling system of the battery to ensure that the water is added at the correct level each time). Connect the battery after filling

Connect to the power socket of the forklift.

【 Go Back 】 | 【 Print 】